Earthquake Sound Electronic Keyboard MB1 User Manual

Sound That Will Move You.  
MB1  
Owner’s Manual & Warranty  
The Sound That Will Move You.  
Earthquake Sound reserves the right to amend details of the specifications without notice.  
Copyright © Earthquake Sound Corporation  
Earthquake Sound Corporation • 2727 McCone Avenue Hayward CA, 94545 • Phone: 510-732-1000 Fax: 510-732-1095  
 
Installation A,B,Cs  
Thank You  
Congratulations on your purchase of the world's most powerful and accurate bass synthesizer.  
Whether this is your first Earthquake Sound product purchase, or you are already a supporter, you  
will thoroughly enjoy the MEGA BASS synthesizer.  
INSTALLATION  
MEGA BASS Digital Synthesizers are required to be installed in the signal path between a head unit and an external  
amplifier. Additionally it can be installed after an equalizer, but must be installed before a crossover.  
Now that we have your attention please allow us to break down the basics of bass and how it can  
effect your systems performance. Regardless of your age or musical preference, adding low  
frequency extension to sound system is an experience that audiophiles can appreciate. Whether you  
listen to classical music, rock music, rap music or if your a pure bread competitor, bass will truly  
enhance the performance of your system. With that said, some people enjoy more bass than others  
and for that reason MEGA BASS comes with a dash mountable remote and also includes a bass  
management center for easy control of the bass potency. So no matter what music you prefer MEGA  
BASS is for you.  
Now that this is complete, you just need to hook up the power, ground and trigger then run the wire to the dash remote  
and now you have instant bass at your finger tips. But with that said you should continue to read on. It will give you a more  
visual understanding of the product that you have just purchased.  
Remote Bass Control  
Remote Bass Control  
Moving on. Now that your ready to rock, we would like to recommend that read this manual in it's  
entirety so that you can fully understand the installation instructions and what that big red button  
does...before you go pushing it.  
PH2000WD/1  
SUB OUT  
Features of the MEGA BASS Digital Synthesizer:  
- Advanced Digital Bass Restoration System  
- Subwoofer Maximization Control Center  
- 100% Voltage Output Enhancement  
- Dash-Mounted Remote Control  
EQ7000PXi  
PH2200W/4  
- Portable Music Enhancement  
- Woofer Protection Circuitry  
Factory Settings Shipped Options  
Bass Frequency  
Bass Bandwidth  
Bass Output Control 5 volts  
Input Circuit  
Ground Isolation  
Subsonic Filter  
40Hz  
Wide  
27Hz - 63Hz  
Range from 30Hz - 250Hz2.5,  
7.5 or 10 volts  
FEATURES SUMMARY  
Balanced Unbalanced  
Isolated  
33Hz  
200 Ohm or Ground  
25Hz, 30Hz, 35Hz, 40Hz, 45Hz  
Advanced Bass Maximization:  
The MEGA BASS Digital Synthesizer contains a bass maximization circuit that perfectly reproduces and pumps low  
frequency info back into the voltage line. Which means that the synthesizer will enhance bass impact when using CDs,  
Tapes and even portable media players, such as iPods and MP3 players.  
Bass Circuit:  
This is how MEGA BASS allows you to control your new found bass. This cool equalization circuit contours the restored  
bass to your speaker system.  
Easy Access Dash Mount Control Center:  
MEGA BASS is designed to be mounted anywhere in your vehicle, with the exception of the obvious things like the  
bumpers and in the gas tank. The MEGA BASS package comes with a dash mount control center which allows you to  
control the intensity of your systems bass output right from the drivers seat. In addition the dash mount unit comes with a  
built dual LED that dims and brightens as the bass increases and decreases.  
DCF D.C. Filter:  
The DCF over drive circuit allows the user to have massive bass while protecting the speaker from DC. failure that is  
typical in other bass enhancement device.  
Bass Expander Limiter:  
The MEGA BASS circuitry produces huge amounts of hard hitting, concrete shattering bass without damaging your  
speakers. The Bass Expander Limiter circuit allows MEGA BASS to enhance the bass output of any audio system while  
controlling damaging burps.  
All specifications are subject to change without notice.  
4
WWW.EARTHQUAKESOUND.COM  
EARTHQUAKE SOUND • MEGA BASS DIGITAL SYNTHESIZER  
5
 
Top Over View  
Internal Over View  
OVER VIEW OF MEGA BASS  
INTERNAL VIEW OF MEGA BASS  
The Outside  
The Inside  
1) Inputs: The inputs of MEGA BASS use a balanced input circuit to help minimize feed back. They are also  
designed to handle very high signal voltage up to 15 volts.  
1) Input Grounding: For most systems you can leave this jumper set in the BALANCED position. In some  
systems, the source unit may look for a ground through the RCA connectors. In that event, you should go ahead and  
change the jumpers to the UNBALANCED position.  
2) Outputs: These RCA connectors should be connected to the next component after MEGA BASS, such as a  
crossover, equalizer or amplifier. Just remember that MEGA BASS should be in line before a crossover.  
2) Ground Isolation Jumpers: Occasionally alternator whine may appear in a system because the source unit  
and amplifier may use different grounding. To help in this situation, we have provided alternative grounding connections.  
Make sure your system is turned OFF bore you move these jumpers.  
3) Dash Input Control: This allows you to connect MEGA BASS to the remote control knob. You can mount the  
knob anywhere you want, although somewhere in the font of the vehicle is most common. (Remote Must Be Connected  
For The Unit Operate Correctly)  
3) Bass Output Control Jumpers: Not all systems are designed the same, some systems are designed strictly  
for SPL while other are for average use. MEGA BASS's maximizer circuit can either increase or decrease the signal  
voltage of the bass restoration circuit. Depending upon your system, you may want to change these jumpers to a higher or  
lower setting to maximize your bass output and protect your speakers. In most systems the factory setting will suit you  
fine. We recommend that you try the factory setting before any other.  
4) Power Connection: This connector allows you to connect the Ground and Remote TURN-ON signals to  
MEGA BASS. Connect all of the wires to their appropriate locations in a well lit area and then plug it into MEGA BASS  
where ever you decided to mount it in your vehicle.  
5) Bass Controls: These 2 knobs control the bass functions fo MEGA BASS.  
The SWEEP knob allows you to pick the center frequency that you want MEGA BASS's restoration circuit to maximize.  
The WIDE knob adjust how wide of a frequency range MEGA BASS will effect.  
6) Power: When you have connected all of your wires correctly the POWER light should illuminate. If it does not  
then you need to check your wires.  
3
BASS OUTPUT  
J6  
10+ v  
7.5 v  
5 v  
2.5 v  
2
J5  
200-Ohm  
ISO  
UNBAL  
Ground  
LEFT  
RIGHT  
J1  
J2  
5
6
1
POWER  
BAL  
Ground  
Positive  
Remote  
1
2
3 4  
All specifications are subject to change without notice.  
6
WWW.EARTHQUAKESOUND.COM  
EARTHQUAKE SOUND • MEGA BASS DIGITAL SYNTHESIZER  
7
 
Placement and Mounting  
Bass Control Center Adjustments  
INSTALLING MEGA BASS  
Placement and Mounting  
Placement: MEGA BASS needs to be installed in the signal path as close to your source unit as possible, but  
definitely before any crossover circuit. Although MEGA BASS is close to the source unit's signal, the chassis is usually  
mounted in the rear of the vehicle as close to the amplifiers as possible. We recommend connecting the MB1 to the  
EQ7000PXi SUB OUT and have it drive the bass amplifier.  
ADJUSTING THE BASS CONTROL CENTER  
The bass response in a system is affected by four factors:  
1. The acoustics of the vehicle  
2. The locations of the speakers  
3. The music on the tape, CD or source unit  
4. The speakers and or speaker enclosures  
Mounting: Once you have selected a permanent mounting location, position the unit and mark the appropriate  
mounting holes with a pen or pencil. Before doing anything else, make sure you are not about to drill a hole in a gas tank  
or pierce existing wires or cables. Now drill a small pilot hole and mount the unit.  
Because of the variations in the recording process we developed MEGA BASS to help restore any low frequencies lost  
during the recording process or from source units, however, the acoustics of various environments are different. With this  
in mind our engineers developed this fantastic system.  
Electrical Connections  
WARNING: Failure to disconnect the negative terminal of your battery prior to installation may result in  
severe shock or damage of you system components.  
The SWEEP control allows you to select a center frequency between 27 and 63Hz. The WIDE control then allows  
you to control the shape of the filter centered around the SWEEP frequency.  
SETTING THE BASS OUTPUT CONTROL  
Remote In: Connect a 22 to 18 gauge wire from the head-unit's remote turn-on to the REMOTE-IN connector of  
MEGA BASS.  
MEGA BASS is the most powerful bass component on the market. It is able to leap to dramatically enhance any  
audio system to audiophile status or preference. MEGA BASS is equipped with several different bass output selections. If  
you should need to change the settings, please use the chart below for guidance. Before making any changes try listening  
to the factor settings...they may be just what your looking for.  
Positive(+12v) Connection: Insert and 18 gauge or larger wire into the connector labeled POWER on the  
connector of MEGA BASS. Connect it to a good constant source of 12 volts, fused at 1-amp.  
Ground Connection: Use the same gauge wire you did for the 12v connector on MEGA BASS's NEGATIVE  
terminal of the battery, a ground bus, or a verified ground location. The factory head unit ground is not a good ground.  
When all connection are complete you may reconnect the negative battery terminal it's original state.  
Remote Bass Control  
RECOMMENDED SETTINGS  
Setting  
2.5 Volt  
5 Volt  
7.5 Volt  
10 Volt  
Amplifier Input Voltage Minimum Speaker Size  
Remote Bass Control  
3 Volts or less  
5 Volts or less  
7.5 Volts or less  
10 Volts or less  
8"  
10"  
PH2000WD/1  
12"  
Some Kind of Beast  
SUB OUT  
EQ7000PXi  
PH2200W/4  
DPF D.C. Protection Filter  
Many car audio systems truly push the limits of their subwoofer, without really knowing it. Tuned  
enclosures affect the roll-off of many speakers, yet lots of source material forces the speakers to play lower  
than expected. The net result i s wasted amplifier power and damaged speakers. MEGA BASS's DPF  
Overdrive is a programmable subsonic filter. It allows you to only let the speaker play as low as it should be  
played. Because every system is different, we allow you to change the DPF roll-off frequency to whatever you  
choose.  
REMOTE BASS CONTROL INSTALLATION  
Placement and Mounting  
The remote bass control may be mounted under the dash using its own bracket or through a custom hole in the  
dash. It should be within reach of the driver.  
Installation  
The bracket is attached to the remote and mounts with two screws which attach to th underside of the dashboard,  
or where ever you prefer. Find your preferred location, mark holes, drill pilot holes and then mount the unit.  
All specifications are subject to change without notice.  
8
WWW.EARTHQUAKESOUND.COM  
EARTHQUAKE SOUND • MEGA BASS DIGITAL SYNTHESIZER  
9
 
Trouble Shooting  
Specifications  
TROUBLE SHOOTING  
MEGA BASS SPECIFICATIONS  
No Power  
Maximum input level....................................................15 Vrms  
Maximum output level..................................................13.5 Vpeak  
Frequency response....................................................10Hz-80kHz; ±0.3dB  
Total harmonic Distortion.............................................0.001%  
Balanced input noise rejection.....................................> 60dB  
Input impedance..........................................................10 Kohms  
Output impedance....................................................... 150 Ohms  
Power supply............................................................... High headroom PWM  
Power draw..................................................................160mA  
Recommended fuse rating.......................................... 1 Amp  
If the LED on your dash remote is not on, check the POWER light on the chassis of MEGA BASS. If the POWER  
light is on you will want to check to make sure that the cable connecting the remote to the chassis is not pinched or  
disconnected. If th POWER light is off check to make sure that the power wire and remote turn on wires are connected or  
a fuse has not blown.  
No Restoration  
When your system is playing and yet you don't hear any difference in the sound, try turning the knob clockwise. If  
you still don't hear any affect, then you need to make sure that you have MEGA BASS in the right part of the signal chain.  
Sound is Distorted  
Should your system sound distorted or your speakers are moving way too much, you should decrease the amount  
of bass restoration by turning the dash control knob counter-clockwise. You should also raise the DPF frequency or lower  
the setting on you Bass Control.  
Still No Good  
Adjust the Bass controls by turning the sweep control clockwise to raise the center frequency. If you still have  
distortion, you should power down MEGA BASS, and change the bass output settings inside the unit (See Page 7).  
Dimensions..................................................................H=1-1/8" W=8" D=5-1/2" + 1/4" For RCAs  
1.70 Lbs  
Weight.........................................................................  
All specifications are measured at 14.4 VDC. As technology advances Earthquake reserves the right to continuously  
change our specifications.  
All specifications are subject to change without notice.  
10  
WWW.EARTHQUAKESOUND.COM  
EARTHQUAKE SOUND • MEGA BASS DIGITAL SYNTHESIZER  
9
 

Dyson Vacuum Cleaner PN18001 01 03 User Manual
Echo Trimmer 99944200545 User Manual
EDGE Tech Printer QL Series User Manual
Electro Voice Portable Speaker EVM 12L User Manual
Electro Voice Range P3000RL User Manual
Euro Pro Iron GI488H User Manual
Exmark Lawn Mower 4500 358 User Manual
Giant Water Pump GP8055 User Manual
Gitzo Camcorder Accessories G1410 User Manual
G Technology Portable Media Storage 0G02537 User Manual