Earthquake Sound Speaker HoLeeS 12 User Manual

Sound That Will Move You.  
Introduction to HoLeeS-12  
Congratulations and thank you for trusting in us  
and acquiring thenew HoLeeS Competition subwoofer,  
another incredible subwoofer from the mind and soul of Mr.  
Joseph Sahyoun (President of Earthquake Sound). “I really  
worked very hard on this driver for several years now, and  
wanted to perfect every aspect of the driver before it was  
released.”  
uses a voice coil that is built with an aluminum bobbin and  
military-grade flat surface wire. The voice coil is over 3” in  
winding height and diameter which makes it one of the  
most respected drivers for producing high excursion, not  
only does it move a lot when you press on it, it has the  
electrical force necessary to move it the distance of the  
actual voice coil. During movement, this driver pulls less  
current from your amp than any other speaker on the  
market. Since it is designed and optimized to have a higher  
impedance during working periods (reactive impedance), it  
never goes into compression and to do so it would have to  
move double what is out there. The “PSP” terminal (patent  
pending) allows the users to have their speaker in 2-ohm,  
dual 4-ohm or 8-ohm. As you can see this terminal and the  
rest of the speaker are the first of their kind and we are  
extremely proud tobe the brains behind them.  
“This sub is constructed from the finest parts on the  
planet; and I mean it.” When it comes to the surround, much  
attention to detail is required to accommodate the huge  
amount of excursion and pressure that will be applied. The  
surround uses Polyether Draw, the strongest and longest  
lasting material available. When the driver is in a long  
excursion situation, you will not start to see any  
deformations or dimples unless the speaker is being  
pushed to it’s absolute max peak. Unlike many  
subwoofers, HoLeeS’s surround will not deteriorate after a  
few years of hard-core pounding; the surround has a  
working life span of 10 years plus. This wide surround will  
easily outlast any other and its many qualities make it the  
widest, longest lasting and most reliable surround, period.  
The driver is constructed with a unique triangular  
bridge type design. The voice coil pushes on the flat piston,  
not the cone. The cone is used for assembly purposes only.  
HoLeeS’s cone is connected to the flat diaphragm and its  
lattice structure in the middle, creating the triangular  
system that removes cone distortion caused by wobbles,  
found in typical speaker designs. Earthquake's HoLeeS  
Earthquake Sound is a reputable manufacturer of  
high-end home and mobile audio products for nearly 20  
years. You will notice that the engineers and other parties  
involved with the production of these fine subs covered a lot  
of ground making sure that every user is satisfied and  
educated as much as possible. If there is anything that you  
do not understand or need help with or if you have  
comments please feel free to contact us at (800) 576-7944  
or email to [email protected]. Thank you once  
again for your support and we appreciate you business.  
Recommended Power For One Subwoofer  
Minimum  
Optimized Maximum  
Don’t  
Legend  
HoLeeS-15  
HoLeeS-12  
HoLeeS-10  
1000W  
1500W  
3000W  
6000W  
12000W  
24000W  
Blue (Minimum):  
Yellow (Optimized):  
Red (Maximum):  
Black (DON’T):  
If you are powering your sub in this This zone represents the best In this zone low-distortion and sound In this zone the chances of failure are  
range, it will operate comfortably with compromise between long-term quality become compromised.  
A
almost inevitable. When exposed to  
zero strain or fatigue. Power ranges reliability, high-output and low- small amount of SPL can be gained excessive heat and/ or mechanical  
this low will not damage your distortion. If you are operating your in this zone, but only a couple of dB. stress the driver will loose sound  
speaker, but it wont capture the subwoofer in this range you are Remember that the more you travel quality, SPL and could seriously  
Subzero full capabilities.  
taking advantage of the best low out of the recommended power damage the driver or you vehicle.  
distortion and sound quality that the range the greater the chances of SUBWOOFERS OPERATED IN  
Subzero is capable of delivering failure and warranty rejection. Be THIS ZONE WILL NOT BE  
between the recommended power.  
wise and use extreme caution and COVERED BYWARRANTY.  
care with your speakers.  
 
Sound That Will Move You.  
Driver Specifications  
Net Weight: 99.6 lbs  
Qts: 0.277  
HoLeeS-12  
Revc: 2.000ohm  
Levc: 5.946mH  
Fo: 26.395Hz  
No: 0.201%  
Cut out hole 11 1/2" (292mm)  
SPLo: 85.0dB  
Vas: 1.17CuFt  
Sd: 53.000msqM  
Cms: 83.043uM/N  
Mms: 437.8253g  
Mmd: 430.809g  
Max Power: 10,000 Watts  
Mounting depth:  
11 7/8”  
(301.625mm)  
BL: 22.250TM  
Qms: 4.915  
Qes: 0.293  
Application / Box Design SPL Burping  
IMPORTANT  
8Ft.  
7Ft.  
6Ft.  
5Ft.  
4Ft.  
Tune @ 65Hz  
Tune @ 65Hz  
Tune @ 65Hz  
Tune @ 65Hz  
Tune @ 65Hz  
To prevent serious damage or injury  
call Earthquake Tech-support  
before powering up the HoLeeS  
subwoofer. If the subwoofer is not  
wired correctly and a malfunction  
occurs, the damage may void the  
warranty. So please help us help  
you, and give us a call toll free.  
Tech-Support: 800•576•7944  
For more enclosure designs and or  
technical support please feel free to  
contact us.  
Ported Enclosure  
16” (406.4mm)  
22” (558.8mm)  
8”  
Outer volume: 3.259 cubic feet  
(203.2mm)  
Inner volume: 2.5 cubic feet / Tuned @ 68Hz  
Port surface: 43.5sq. inch  
Port length: 8” (203.2mm)  
Port length may vary depending on frequency  
Wall thickness: 1” (25.4mm)  
Front baffle: 2” (50.8mm)  
16”  
(406.4mm)  
 
Please Read  
Instructions  
Thoroughly  
Sound That Will Move You.  
S
Wiring Configurations  
The HoLee-S subwoofer comes equipped with 2 voice coils (dual 1 ohm), it can be used in .5 or 2  
ohm configurations. The terminal comes equipped with fused jumpers, please note that center  
terminals are not operational.  
Parallel  
1/2 Ohm  
1-CHANNEL  
1-CHANNEL  
1-OHM LOAD  
(voice coils in parallel)  
(No Fuses)  
1-OHM LOAD  
(voice coils in parallel)  
(No Fuses)  
VC #1  
VC #1  
S
S
Series  
2 Ohm  
+
1
+
2
+
1
+
2
2
2
1
1
DO NOT  
USE  
DO NOT  
USE  
Normal  
MONO 1-OHM  
MONO 1-OHM  
AMPLIFIER TERMINAL  
 

Electro Voice Portable Speaker S12 2A User Manual
Euro Pro Electric Grill K4820H User Manual
FOCUS Enhancements Digital Camera FS 4 HD1 User Manual
Fostex Musical Instrument FD 4 User Manual
Fujitsu Power Supply MB3887 User Manual
Garland Convection Oven MST45R User Manual
Garmin Marine GPS System 205 E 205W User Manual
Gemini Turntable TT 01mkii User Manual
GE Water Heater JBS15M User Manual
Golden Technologies Mobility Scooter GB106 User Manual